Filter
Top Products
12
Specifiche Tecniche
Parametro Condizioni di misura Valore
Numero di canali: - 2
Potenza: 8 Ω @ 1%THD
4 Ω@ 1%THD
2 Ω@ 1%THD
50W
100W
200W
Distorsione armonica totale: 1W, 8 Ω 0,02%
Sensibilità: Per 50W @ 8Ω - Volume = 48
Ingresso sbilanciato
Ingresso bilanciato
0.5 V
rms
1 V
rms
Tempo di salita: A piena potenza 2.2 µs
Slew rate Limitato dalla banda a piena potenza 30V/ µs
Risposta in frequenza: Attenuazione –0dB
Attenuazione –6dB
<1Hz - 160kHz -3dB
<1Hz - 160kHz -3dB
Rapporto Segnale/Rumore: Attenuazione 0dB
Pesato-A
Migliore di 100dB
riferito a 50W @ 8 Ω
Tensioni utilizzabili: - Vedi l’etichetta posteriore
Consumo Normale funzionamento
Massimo
350W
700W
Peso 40 kg
Troubleshooting
Symptom Cause Remedy
Power cord incorrectly plugged Make sure the power cord is correctly
plugged into the wall outlet
Burned-out fuses Check fuses in the fuse panel (after
unplugging the power cord from the wall
outlet
)
above the IEC inlet and replace the
m
with new ones of the same type
No display on
No sound
Rear switch not turned ON Set the switch to “1”
Momentary low voltage on mains plug Turn off the rear switch, wait 5 seconds
than turn ON again.
Error message after power ON
Internal Failure Contact your Audio Analogue retailer
Recording is impossible Incorrectly selected source Select the right source using the recording
selector
No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries) Remote control doesn’t work
You’re standin
g
too far or on an exceedin
g
angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.