Filter
Top Products
12
TROUBLESHOOTING
Symptom Cause Remedy
The unit is in STANDBY mode Press the STANDBY button on the front
panel of the unit or the STANDBY button
on the remote controller
Incorrectly plugged power cord Make sure the power cord is correctly
plugged into the wall outlet
Display is off
No sound
No response from the unit
Burned-out fuses Contact your Audio Analogue retailer for
fuse check/replacement
Faulty or incorrectly plugged connectors
between Primo VT Tuner and the amplifier
Check cables and their connection Display is on
No sound
Incorrectly selected source on the amplifier
Check that Primo VT Tuner is correctly
selected through the amplifier input
The unit is on but there is no sound
The unit is in “Storage” mode Complete storage procedure by pressing
the STORE button on the front panel or on
the remote controller
It is impossible to tune in a radio station Faulty or incorrectly plugged antennas. Check that the antennas are correctly
plugged and placed (FM antenna has to
be unrolled as much as possible). Try
replacing both the antennas.
Primo VT Tuner works but the display is
off
Faulty or incorrectly plugged front panel. Contact your Audio Analogue retailer for
connections check and front panel
replacement
No battery/ worn-out battery Place/replace battery (2 ‘AAA’ batteries) Remote controller doesn’t work
You’re standing too far or on an exceeding
angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio
Analogue retailer.