ATI Technologies ATP 8500 Stereo Amplifier User Manual


 
Page 25
Speaker Setup
Main Speakers Large
Center Speaker Large
Surr. Speakers Large
Subwoofer Yes
Sub Freq. 60 Hz
Bass Mix On
Exit
AN EXAMPLE OF THE SPEAKER SETUP MENU
Speaker Setup Menu
• The speaker setup defines which speakers can
handle full-scale low frequency signals as in
the case of “Large” speakers. It also defines
whether the bass from these channels must be
redirected to those which have “Large”
speakers and/or a subwoofer.
• The speakers that can handle full frequency
signal are set to be Large.
• The speakers that cannot handle full
frequency signal are set to be Small. The bass
signal does not go to Small speakers but is
redirected to Large speakers and/or subwoofer.
• If a speaker is not present (e.g. Center) you
should set it to “None.”
• You can set the subwoofer crossover frequency
from 40 Hz to 140 Hz. The crossover frequency
defines the frequency below which the low
frequency signal does not go to Small speakers,
but is redirected to Large speakers and/or a subwoofer.
• Bass Mix duplicates the subwoofer information to
both Large speakers and subwoofer. You may desire
this in same cases to get more bass from the system.
• EXIT returns to the main menu.