Open as PDF
Setting the AUX ZONE NAME mode
You can change the AUX Zone Name when AUX ZONE is set to ON.
Setting the AUX Mode (V-Link)
You can input TV/video sound by connecting an optional Ai-NET/RCA
Interface cable (KCA-121B) or Versatile Link Terminal (KCA-410C) to
You can change the AUX NAME display when AUX is set to ON. Press
/ENTER when AUX is set to ON, and select AUX NAME by
turning the Rotary encoder, then press /ENTER.
After that, turn the Rotary encoder to select the desired AUX name.
If the KCA-410C is connected, it is possible to select two AUX names.
• Via KCA-410C, up to 2 external devices with RCA output can be
connected. In this case, press TUNER/SOURCE to select AUX
mode, and then press TUNER/SOURCE again to select your desired
Setting the Changer Name
When an optional changer is connected, you can set the displayed mode
• The setting can be made only when a changer is connected. When
two changers are connected, the CHANGER1 NAME/CHANGER2
NAME is displayed, and the setting can be made respectively.
Setting the External Digital Input (DIGITAL AUX)
When an ALPINE Ai-NET compatible digital audio processor
(PXA-H701) and a DVD player (DVE-5207) not compatible with
Ai-NET are connected, set DIGITAL AUX to ON to enjoy 5.1-channel
You can change the D-AUX Name when DIGITAL AUX is set to ON.
/ENTER when DIGITAL AUX is set to ON, and select
D-AUX NAME by turning Rotary encoder, then press
• Press TUNER/SOURCE, and select the D-AUX mode, and adjust
the volume, etc.
• After input selection is completed, turn the ignition off and back on
again. Setting of the optical digital input switch is completed.
• Depending on the connected audio processor, DVD player sound
may continue to be output, even though the source is changed to
another one. If this occurs, set the DVD player’s power to OFF.
Setting the AUX+ Level (AUX IN GAIN)
After setting to ON in “Setting the AUX+ Mode”, this setting can be
Connecting to an External Amplifier (POWER IC)
When an external amplifier is connected, sound quality can be improved
by stopping the power supply of the built-in amplifier.
• No sound is produced by the system when the POWER IC is set to
This unit has a Demonstration feature for the display.
• To quit Demo mode, set to DEMO OFF.
DISPLAY is selected on the setup main menu in step 2.
Volume Level Bar Setting (VOL DISP)
When Volume mode is set to ALL, you can select the volume level bar
for ZONE1 or ZONE2 on LCD display.
AUX (Initial setting) / TV / DVD / PORTABLE / GAME
AUX ON / AUX OFF (Initial setting)
CHANGER (Initial setting) / PORTABLE
DIGITAL AUX ON / DIGITAL AUX OFF (Initial setting)
LOW (Initial setting) / HI
LOW : Decreases the external input audio level.
HI : Increases the external input audio level.
ON (Initial setting) / OFF
POWER IC OFF : Use this mode when the front pre-amplifier of the
unit is used to drive an external amplifier
connected to the speakers. In this setting, the
head unit’s internal amplifier has no output to
POWER IC ON : The speakers are driven by the built-in amplifier.
DEMO ON / DEMO OFF (Initial setting)
ZONE1 (Initial setting) / ZONE2