Filter
Top Products
33
D
-Detachable Power Cord Socket - Plug the Detachable
Power Cord into this socket (see Figure 1). The SFP-1 is factory
set for the correct operating voltage for the area in which it is
sold (see shipping box for voltage setting). If a different operat-
ing voltage is required, please contact an authorized Sonic
Frontiers dealer, distributor or the factory directly.
E
- AC Line Fuse
-
This is the AC fuse socket. It may be
accessed with a small slot screwdriver by turning a 1/2 turn
counterclockwise to unlock a spring that ejects the fuse holder
out. The unit is factory installed with a “fast-blo” 1.5 Amp
250V (0.25” x 1.25”) or 0.75 Amp 250V (0.25” x 1.25”)
for European and Asian versions.
F
- Left and Right Channel RCA Single-Ended Audio
Output Connectors - The SFP-1’s RCA single-ended
audio outputs are to be connected to the RCA single-ended
audio inputs of a line level preamplifier, control amplifier,
integrated amplifier or receiver. Left channel output of the
SFP-1connects to the left channel input of control unit and
right channel output of the SFP-1 to the right channel input
of control unit.
G -
Left and Right Channel RCA Single-Ended Phono
Stage Input Connectors
-
These inputs accept a single-
ended input connection from a turntable’s output connectors.
The turntable equipped with a Moving Coil or Moving Magnet
Cartridge (see operation section for proper setup) connects
to the SFP-1. Left channel output to the left channel input of
the SFP-1 and right channel output to the right channel input
of the SFP-1.
H
-Ground Post - All turntable ground wires should be connect-
ed to the SFP-1 ground post to prevent any “hum” from interfer-
ing with the music signal.
D GF
Figure 1 - Align socket pins to corresponding holes and push together firmly.
HE