Filter
Top Products
27
3.5 SOURCE SETUP / PRESETS
This is where you set up each Source and Path according to how you want them to be used.
Copy MAIN to ZONE or REC:
If you want MAIN to always be copied to another Path (see section 4.3), change ‘Manual’ to ‘Always’. This
is recommended if you want a Source that only has digital audio output to be used in ZONE2, ZONE3, or REC,
or if you want MAIN and another Path to always play the same Source. ‘Always’ setting is not
recommended
if you want Source selection to be independent – in this case, see the highlighted part of section 2.2.
Source Setup:
Besides setup of each source, DVD, TV, and SAT have expanded memory allowing you to set multiple
configurations, which are useful for two reasons:
• Use multiple layers for same source, with different video adjustments on each layer, such as aspect
ratio control (see section 4.11).
• Use multiple layers with different sources when you have more than nine source components.
To enable DVD2, DVD3, DVD4, TV2, TV3, TV4, or SAT2, at the top of its submenu change SAME AS: “Disabled”
to either “Custom” to create its own Source Setup profile, or to any of the other inputs, to use the same
Source Setup that they use but so that each layer can have different video adjustments.
Once set up, select a layer either by pressing the Source button one, two, three, or four times, or through the
direct-access macros in Appendix A.
3. SETUP MENU continued …
5. SOURCE SETUP / PRESETS
a. CD
b. 2-Ch
c. 6-Ch
d. TAPE
e. FM/AM
f. DVD1
g. DVD2
h. DVD3
i. DVD4
j. TV1
k. TV2
l. TV3
m. TV4
n. SAT1
o. SAT2
p. VCR
q. AUX
r. COPY MAIN->ZONE2: Manual
s. COPY MAIN->ZONE3: Manual
t. COPY MAIN->REC : Manual