Filter
Top Products
4.3 MANUALLY COPYING THE MAIN PATH TO ZONE2, ZONE3, OR RECORD
When Main is copied to another Path, the Source selected in MAIN is directed to ZONE2, ZONE3, or RECORD
from either analog or digital inputs.
If a source component’s audio is connected to the AVM 50 using digital connection only, then the Copy
function is the only way to deliver the sound to another Path.
Front Panel
Press MAIN simultaneously with ZONE2, ZONE3, or REC. Use MAIN to select the Sour
ce.
Remote Control
Make sure the appropriate control mode is set, or REC Path is selected, then press COPY.
When MAIN is copied, the display for the other Paths reads “–MAIN–> ZONE2” (or ZONE3 or REC), along
with the information normally displayed. Copy can also be set permanently – see section 3.5.
Down-Mixing to 2-Channel Stereo:
The Center, Surround, and Rear channels can be mixed into the Left and Right Channels for the ZONE2,
ZONE3, TAPE, and VCR outputs. This can be done by the DVD player or the AVM 50:
• AVM 50 Down-mix: If the digital audio output from your DVD player is connected to the AVM 50,
the AVM 50 down-mixes 5.1 channels into 2.0 whenever you copy MAIN to another Path. This
applies whether the input is, Dolby Digital, DTS, or 6-Ch input.
• DVD Player Down-mix: If the Left/Right analog outputs from your DVD player are connected to the
AVM 50’s Analog Audio-In, the Dolby Digital down-mix done by your DVD player can be used for
ZONE2, ZONE3, TAPE, and VCR outputs, without having to copy MAIN. Note that DVD players do not
normally provide a down-mix for DTS material.
4.4 SOURCE SELECTION
After making sure that you are in the appropriate Path (Front Panel) or appropriate control mode is set
(Remote Control), select a Source.
6-Channel Analog Audio Input:
The 6-Ch audio can be routed to ZONE2, ZONE3, and RECORD outputs as long as Copy mode, which creates
the stereo down-mix, is used (see section 4.3).
Source Seek (Remote Control Only):
The SOURCE SEEK keys detect the previous/next active Source, while
thekey advances one Source at a time. To increase seeking speed, set all unused
HDMI and Component video inputs to ‘None’ (see section 3.5).
4. OPERATION continued …
45
PIP
COPY
PIP SWAP MOVE
SSP SOURCE
COPY
AUX TAPE
DVD
TV
SAT
VCR
2-Ch
CD
REC
FM
AM
6-Ch
S
S
P
P
A
T
H
SOURCE SEEK