Antex electronic SX-33E Stereo System User Manual


 
6
MINIMUM HARDWARE RECOMMENDED
! 12MHz 386 PC or compatible
! 28mSec average access hard disk
! 1:1 Interleave hard disk controller
! Mouse
! VGA display
ADAPTER INSTALLATION
Make sure the main power to your computer is OFF. You will
need a full-size, 16 bit/AT slot. If you are unfamiliar with the inter-
nal design of your computer see its "Guide to Operations" manual
for step by step installation procedures.
Read JUMPER SETTINGS and CONNECTIONS for information
about configuring the adapter before plugging it into the slot.
JUMPER SETTINGS
The jumpers on the Z1, Z1e, SX-3, SX-33, SX-33b and SX-33e
have been preset at the factory to insure proper operation for
multimedia testing. Refer to Figures 11 & 12 in the back of the
manual for the jumper locations.
NOTE: These jumper numbers correspond to Z1/Z1e boards
marked 9000-2319-300x and SX-3/SX-33 9000-2334-300x
boards. Refer to Figure 13 for setting jumpers on earlier versions.
The interrupt is currently set to 10 by the JP7 jumper, but may be
changed to 2, 3, 5, 7, or 11 if the Windows drivers are configured
accordingly. Figure 3 illustrates the use of JP7.