Antex electronic SX-33B Stereo System User Manual


 
8
If you are connecting a SCSI CD-ROM to a Z1e board
(marked F2319-4 Rev A or B) under Windows NT, use
Windows NT driver V0.8e or later.
If a Z-Wave is installed, the MPU-401 address is set by
JP5 & 6 (Note that these jumpers simultaneously set the
Audio I/O address). The available addresses are 300h,
320h and 380h(default). Figure 4 shows how the MPU-
401 address is selected.
CONNECTIONS
There is a five pin internal CD ROM header for connecting a
Z1/Z1e to audio output of a CD-ROM. A 50-pin header is pro-
vided on the Z1/Z1e for connecting to an internal SCSI CD-ROM.
For more information about the configuration of these and other
headers located internally on the Z1, Z1e, SX-3, SX-33, SX-33b
and SX-33e, refer to the Connector Descriptions, Figures 11 & 12,
in the back of the manual.
When the internal modifications are completed, push the adapter
firmly into an expansion slot. Take care not to bend or break any
components. The adapter should be seated firmly and the bracket
should be flush with, and secured to, the support rail along the
back edge of the computer.
Now make the connections at the back of the adapter, such as
audio input, output, microphone, etc. Refer to Figure 5 for these
connector locations on the Z1, Z1e, SX-3, SX-33, SX-33b and SX-
33e.