Filter
Top Products
Tuner Modules
43
Tango / Mi-Series Audio Controllers
Removing the Pre-Installed DAS-AMFM Tuner Module
Mi Series Audio Controllers include one DAS-AMFM Tuner Module as a standard accessory. Since each tuner
module uses one source input on the audio controller, in some cases it may be desirable to remove the tuner
module in order to use that source input for other purposes.
1. Remove the cover from the controller.
2. Carefully remove the ribbon cable from the tuner module.
3. Remove the screws from the Tuner module cover plate at the right top corner of the rear panel and slide
the tuner module out of the chassis.
4. Place all jumpers in the “Off” position (FIG. 64).
5. Replace the unit cover.
FIG. 63 Audio Controller - 2-wire end of cable connected to the tuner assembly.
FIG. 64 Audio Controller Jumper Configuration (Dual Tuners)
Note the position of the Red and White wires
relative to the connector
Tuner 1 jumpers (in OFF position)
Tuner 2 jumpers (in OFF position)
Top Left of Rear-Board Pin Bus
3
1
3
1
3
1
3
1
TUNER 1
Jumpers
TUNER 2
Jumpers