Filter
Top Products
Setup and Configuration
37
Tango Series Audio Controllers
2. The following screen is displayed (FIG. 51):
3. Select MRC to view the software version of the Main Controller and keypads. The following screen is
displayed (FIG. 52):
Select Quit to return to the About screen, where another unit can be selected.
Select Main Keypads to view the software version of the Main Keypads. The following screen is
displayed (FIG. 53):
“OK” returns you to the About MRC screen.
Program LCD KP
Select Program LCD KP to display the Reprogram LCD Keypad screen (FIG. 54).
This option puts the Controller in the correct mode to allow LCD Keypads to be programmed. The
communication on the I2C bus will be stopped so that the programming of the LCD keypads is not interrupted.
Once the LCD KP has been programmed, select QUIT to exit the screen. Communication on the I2C bus will
resume.
FIG. 50 System Setup Mode - About
FIG. 51 About - Make a Selection
FIG. 52 About MRC #
FIG. 53 MRC Main Keypads
FIG. 54 Reprogram LCD Keypad screen