Filter
Top Products
Setup and Configuration
28
Tango Series Audio Controllers
MRC Setup Mode Options screen
Select Setup in the MRC Setup Mode screen (FIG. 24) to access the MRC Setup Mode Options screen
(FIG. 25).
Program - Access the Program Mode screen, where you can select and program an IR Source
device.
Gain/Attenuation - Access the Gain and Attenuation screens to adjust the Input Attenuation and
Output Gain for each audio source.
Paging - Access the Paging screens to set the screen volume and turn Paging ON/OFF in each
room/zone.
Exit - returns to the previous screen.
Programming Source Equipment
1. Select Program from the MRC Setup Mode Options screen (FIG. 25) to access the Program Mode screen
(FIG. 26), where you can select a source to program.
2. Select a Source to program (1-8). This invokes the Select Source # Type screen.
FIG. 25 MRC Setup Mode Options screen options
Exits this screen
To the MRC Paging screens
To the MRC Gain/Attenuation Mode screens
To the MRC Setup Mode screens
Each source can be leveled to approximately the same level (via the Gain/
Attenuation settings) to insure a smooth transition between source selections.
Placement of the Remote - The audio source remote should be located about 6 to
12 inches away from the IR port on the Tango Controller. The path between the
devices should be unobstructed with a clear line of sight. Fluorescent light fixtures
and bright sunlight may interfere with the learning process. When possible use only
incandescent lighting during the programming session.
FIG. 26 Program Mode (Select a Source)
FIG. 27 MRC Setup Mode - Select Source # Type