AMX DAS-T0804-SIG Stereo System User Manual


 
Setup and Configuration
31
Tango Series Audio Controllers
3. Select a source (1-8) to be adjusted for input attenuation. This selection invokes the Set Input Attenuation
For Source # screen (FIG. 32):
4. Select Increase and Decrease to adjust the input attenuation for the selected device.
5. Select Exit to adjust the input attenuation for another source:
Adjusting Output Gain
1.
From the MRC Gain/Attenuation Mode screen, select “Output Gain” (FIG. 33):
2. The Output Gain Mode screen is displayed. Select the source to be adjusted for “Output Gain”
(FIG. 34).
3. The following screen is displayed (FIG. 35):
FIG. 31 Input Attenuation Mode screen
FIG. 32 Set Input Attenuation for Source # screen
Increasing attenuation will have the effect of dropping the sound level, while
decreasing the attenuation will raise the sound level.
Input Attenuation can be adjusted in increments of 3dB as follows: 0, -3, -6, -9, -12.
FIG. 33 MRC Gain/Attenuation Mode - Output Gain
FIG. 34 Output Gain Mode - Exit
FIG. 35 Set Output Gain for Source # 3