Filter
Top Products
Setup and Configuration
26
Tango Series Audio Controllers
Programming the Tango Controller
The Programming Panel
The IR learning programming controls are located on the front of the Tango Controller. FIG. 21 shows the
front of the Tango Controller with the navigation array to the left of the readout. The array is used to navigate
through the programming and setup of the Controller.
Main Menu screen
Press the center navigation button on the front of the Controller to access the Main Menu screen (FIG. 22).
Options on the Main Menu screen include:
Setup - Accesses the System Setup Mode screen
Backlight - Accesses the Backlight Options screen
About - Accesses the About screen
Exit - Exits the Main Menu
FIG. 21 IR learning programming controls
FIG. 22 Main Menu screen options
Press the center button (Select) to access the Main Menu:
Nav Up
Nav Down
Nav Right
Nav Left
Select
Exits this screen
To the About screens
To the Backlight Options screens
To the System Setup Mode screen
Use the navigation buttons (<< / >>) on the front of the Controller to move from one
option to another, and the SELECT button to make a selection.