AMX DAS-T0804-SIG Stereo System User Manual


 
Tango Series Audio Controllers
2
Tango Series Audio Controllers
Product Specifications
The following table provides technical specifications for the Tango Audio Controllers. Unless otherwise noted,
these specifications apply to both the DAS-T0804-SIG and DAS-T0808-SIG models.
Tango Audio Controllers Product Specifications
Models Available: DAS-T0804-SIG Tango 8-Source, 4-Zone Audio Controller (FG1103-01)
DAS-T0808-SIG Tango 8-Source, 8-Zone Audio Controller (FG1103-02)
Stereo Output: 25 Watts/CH stereo (20Hz to 20Khz @ .1% THD)
Power: 960W max (Actual average usage = 300W)
Zone Support: DAS-T0804-SIG - Four independent audio Zones.
DAS-T0808-SIG - Eight independent audio Zones.
Each Zone is protected thermally.
Zone grouping.
Independent Volume, Bass, Treble, Balance and SRS
®
controls in each
zone.
Stereo Amplifiers: 40 Watts/CH stereo amplifiers (20Hz to 20Khz @ .1% THD).
Amplifiers are protected from overload and thermal runaway.
SRS/WOW
®
: Standard SRS/WOW
®
audio enhancement technology by SRS Labs, on all
zones.
Note: SRS/WOW is a registered trademark of SRS labs, Inc.
Front Panel Components:
Light Bar Blue light bar indicates power status.
LEDs Blue LEDs indicate level status.
Function/Navigation Buttons 5 pushbuttons allow for front panel programming, selection of sources, tun-
ing AM/FM radio stations, or Sirius satellite radio stations (when equipped
with the optional Sirius and/or AM/FM Tuner Card).
IR Receiver This is where you must aim the remotes from your audio source components
so the Controller can learn and emulate those commands.
LCD Display Displays information necessary during the programming steps and afterward
is the display to indicate information about the source input and zone activity.
Rear Panel Components:
Power Switch & Receptacle The master power switch will remain in the ON position normally.
Paging In/Out Ports RCA jacks to connect to Paging devices (any audio input can be used as a
paging device). The Paging device connects to the Controller via the "Paging
In" connector. The “Paging Out” connector is used to carry the page to Zone
Expander(s).
RJ 45 Port Ethernet Port for future expansion
RS-232 Port DB9 connector allows the Tango Audio Controller to receive Controller Com-
mand Messages and provide status messages. This port is intended
primarily for troubleshooting purposes.
AM/FM Antenna Inputs Connections for the AM and FM Antennas.
Audio Inputs Stereo Inputs, 47K impedance, buffered.
Audio Outputs Stereo Looping Outputs, buffered.
IR Outputs DAS-T0804-SIG: Four IR 3.5mm mono output jacks.
DAS-T0808-SIG: Eight IR 3.5mm mono output jacks.
Zone Outputs DAS-T0804-SIG: 4 zone output connectors (connect to Metreau keypads)
DAS-T0808-SIG: 8 zone output connectors (connect to Metreau keypads)
Expansion Port RJ-11 Port connects main Tango Controller with Tango Zone Expanders.
Dimensions (HWD):
(including feet)
4" x 17" x 13.5"
10.16 cm x 43.18 cm x 34.29 cm
Weight: Max. weight with 8 zones - 31 lbs (14.06 kg)