AMX DAS-SIRIUS Stereo Receiver User Manual


 
DAS-SIRIUS Tuner Module
5
DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers
Tuner 1 Jumper Settings
The Tuner Module installed in position 1 must be set to Tuner 1, as shown in FIG. 7:
Tuner 2 Jumper Settings
The Tuner Module installed in position 2 must be set to Tuner 2, as shown in FIG. 8:
Installing the DAS-SIRIUS Tuner Module
Since Mi-Series and Tango Audio Controllers are shipped with a DAS-AMFM Tuner Module pre-
installed in the Tuner 1 position (on the rear panel of the Controller - see FIG. 9), the DAS-SIRIUS
Tuner Module, is typically installed in position #2 (labeled Tuner Option).
Installing the DAS-SIRIUS Module Into Position 2
To install the DAS-SIRIUS Tuner Module into the Position 2 Tuner slot:
1. Remove the cover from the Audio Controller.
2. Remove the Tuner Option cover plate on the rear panel (FIG. 9) to expose the Position 2 mounting
slot for the Tuner Module.
3. Carefully insert the DAS-SIRIUS Tuner Module into the Controller, with the
electronics facing up, and replace the cover plate screws to secure the Module to the Controller.
FIG. 7 Tuner Module - Tuner 1 Jumper Configuration
FIG. 8 Tuner Module - Tuner 2 Jumper Configuration
TUNER 1 Jumpers
TUNER 1 Jumpers
TUNER 2 Jumpers
TUNER 2 Jumpers
TUNER 1 Jumpers
TUNER 1 Jumpers
TUNER 2 Jumpers
TUNER 2 Jumpers