Filter
Top Products
DAS-SIRIUS Tuner Module
2
DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers
FIG. 2 provides orientation for the various internal components that must be accessed to install the Tuner
Module and set the Jumpers.
Setting the Jumpers
While Mi-Series and Tango Audio Controllers support 2 Tuner Modules in any combination, this
document primarily describes installing the DAS-SIRIUS Tuner Module into Position 2 on the Audio
Controller (as TUNER 2), leaving the DAS-AMFM Tuner Module in position 1 (as TUNER 1).
FIG. 2 Audio Controller - Internal view
front
Tuner slots (Top = Position 1, Bottom = Position 2)
20-pin Tuner
Ribbon Cable
connector
20-pin Tuner
Ribbon Cable
Rear-Board Pin Bus
(Controller Jumpers)
Tuner Module Jumpers
(located behind ribbon
cable connector)
rear
Tuner
Modules
panel
Make sure to discharge all static electricity from your body before touching any
components of the Tuner Modules or the Audio Controller. Failure to do so may lead
to permanent damage to the Tuner or Controller.
Because of the location of the Jumpers in the Controller and on the Tuner Module, it
may be easier to make all jumper settings before installing the Tuner Module in the
Controller.