AMX DAS-SIRIUS Stereo Receiver User Manual


 
DAS-SIRIUS Tuner Module
1
DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers
DAS-SIRIUS Tuner Module
Overview
Add Sirius satellite radio functionality to your AMX Distributed Audio system with the
DAS-SIRIUS Satellite Radio Tuner Module (FG1110-02).
The DAS-SIRIUS Tuner Module can be used with both Mi-Series and Tango Audio
Controllers.
All Mi-Series and Tango Audio Controllers come equipped with a DAS-AMFM AM/FM
Tuner Module. Since Mi-Series and Tango Audio Controllers support 2 Tuner Modules in any
combination, the DAS-SIRIUS Module can either be installed in addition to the DAS-AMFM
Module, or the DAS-AMFM Module can be removed to allow 2 DAS-SIRIUS Modules.
Each Tuner Module uses 1 source input on the Audio Controller.
Installation
Installing/removing Tuner Modules requires removing the cover from the Audio Controller, removing
the Tuner Option cover plate from the rear panel of the Controller, installing the Tuner Module, and
setting Jumpers on both the Tuner Module (to specify each Tuner Module as either TUNER 1 or TUNER
2), and the rear board pin-bus of the Audio Controller (to enable/disable Tuner Module slots 1 and 2).
FIG. 1 DAS-SIRIUS Satellite Radio Tuner Module
SIRIUS Antenna
connector
20-pin Tuner
Ribbon Cable
connector
Tuner Jumpers
Tuner
Mounting
Plate
“SIRIUS”, the SIRIUS dog logo, and channel names and logos are trademarks of
SIRIUS Satellite Radio Inc. All rights reserved.
Disconnect all power sources before opening the chassis. Failure to disconnect
power before performing this installation may cause injury or death.