Filter
Top Products
DAS-SIRIUS Tuner Module
6
DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers
The Rear Panel connector at the end of the Tuner Ribbon Cable is connected to the
Controller’s rear board pin-bus (see FIG. 2).
Keep the Tuner Ribbon Cable oriented so that the red stripe is always on top, as indicated in
FIG. 10:
4. Connect the Tuner 2 connector on the ribbon cable to the 20-pin Tuner Ribbon Cable connector on
the DAS-SIRIUS Module (FIG. 11).
Keep the Tuner Ribbon Cable oriented so that the red stripe is always on top, as indicated in
FIG. 10.
Verify that all of the 20-pin connectors of the Tuner Ribbon Cable are securely plugged into
their respective boards.
5. The Controller should only be powered back on once all Tuners are installed.
Removing Tuner Modules
In some cases it is necessary to remove the existing Tuner Module, in order to install a different Tuner
Module. Since each Tuner Module uses 1 source input on the Audio Controller, you may choose to use
the source input for other purposes.
1. Remove the cover from the Audio Controller.
2. Carefully remove the ribbon cable from the Tuner Module.
3. Remove the screws from the Tuner Module cover plate (on the Controller’s rear panel) and carefully
slide the Tuner Module out of the chassis.
FIG. 9 Rear Panel Tuner with Tuner Option cover plate
Position 1
Position 2
(DAS-AMFM installed)
(Tuner Option
cover plate)
TUNER 1
TUNER 2
Be careful not to damage the white ribbon cable on the top of the Tuner Module.
FIG. 10 Tuner Ribbon Cable
Tuner 2 Tuner 1
Rear Panel
RED STRIPE (to Pin 1)
not used