Filter
Top Products
AT6012 Specifications
Page 12
The following applies to all 12 channels being driven simultaneously with
8 ohm loads and an input sensitivity of 28dB gain unless otherwise specified.
Frequency Response
±0.1dB from 20Hz to 20kHz at 1 watt
Phase Response
+5 to -15 degrees from 20Hz to 20kHz at 1 watt
Signal-to-Noise Ratio “A-Weighted”
Greater than 100dB below rated FTC Full Bandwidth Power
Total Harmonic Distortion (THD)
Less than 0.05% at full rated FTC power from 20Hz to 20kHz
Intermodulation Distortion (IMD)
Less than 0.05% from 250 milliwatts to full rated FTC power
EIA 1kHz Output Power*
75 watts @ 8 ohms, 120 watts @ 4 ohms
FTC Full Bandwidth Output Power**
60 watts @ 8 ohms, 90 watts @ 4 ohms
Power Bandwidth FTC
+0-3db from 5Hz to 100kHz
Damping Factor
Greater than 400 from 10Hz to 400Hz
Crosstalk
Greater than 90dB from 20Hz to 20kHz
Gain
Voltage gain of 28dB
Slew Rate
30V/microsecond
Input Impedance
Nominally 28k ohms
Input Sensitivity
1.0 volts for full rated power.
Load Impedance
Safe with all types of loads. Rated for 4 to 16 ohms
DC Output Offset
Less than ±5mV
Transformer
2kVA
Chassis Dimensions (WHD)
17 x 7 x 16 inches (431.8 x 177.8 x 406.4 mm)
Rack Mount Panel (Optional)
Standard 19 inches (482.6 mm) rack mounting (EIA RS-310-B)
Weight
Net 73 lbs (33.18 kg) Shipping 82 lbs (37.27 kg)
**EIA 1kHz Power refers to maximum average power in watts
at 1kHz with 0.005% THD and noise.
**FTC Full Bandwidth Power refers to maximum average power
in watts from 20Hz to 20kHz with 0.03% THD and noise.
All descriptions and specifications are subject to change without notice.