Altec Lansing 6125A Stereo Amplifier User Manual


 
5
Operating Manual 6125A and 4200A Multi-Channel Power Amplifier
4. CABLE REQUIREMENTS
4.1 Input Cables
Be sure to use shielded cable whether balanced or
unbalanced. Shielding which is properly grounded will
protect the signal from outside electrical interference such
as RF, fluorescent lighting, and computer/display emis-
sions. As a general rule, unbalanced or single-ended (tip-
sleeve) lines of less than 10 feet are satisfactory, but greater
distances or noisy field environments require a balanced
signal. Avoid running input lines in close proximity or
parallel to long speaker lines, AC power cables, or power
transformers, as this may generate hum or oscillation.
4.2 Output Cables
These amplifiers are capable of delivering high
levels of output current, therefore the wire gauge used for
speaker cables is particularly important. Inadequate wire
gauge can add significant resistance to the speaker’s own
impedance, especially over long distances, reducing the
power which is actually delivered to the speaker. It could
also result in a decreased damping factor and possible fire
hazard. Since power at the speaker load is of primary con-
cern in system design, we have included a table to best
determine appropriate wire gauge for your application. The
following table lists the resistance per 100 feet of com-
mon copper wire gauges, and also gives the percentage of
the speaker load power which would be lost in an arbitrary
100 ft run of different gauges of 2-conductor copper
speaker wire.
Wire Gauge /100ft 8 load 4 load
#8 .0605 0.8% 1.5%
#10 .1018 1.3% 2.5%
#12 .1619 2.0% 4.0%
#14 .2575 3.2% 6.4%
#16 .4094 5.1% 10.2%
#18 .6510 8.1% 16.3%
Table 4.1: Wire gauge resistance/power loss
This table expresses the power loss as a percent-
age of the load’s power rather than the total amplifier out-
put power in order to accurately determine power loss at
other cable lengths. For example, if you plan to deliver
150 watts to an 8 load through 50 ft of 14 ga. cable, the
power loss in the cable would be half that of a 100 ft run
of #14 wire as shown in the table, or 1.6% of 150W, which
is an insignificant 2.4 watts. However, if you were to run
200 ft of 18 ga. cable to a 4 load, the loss would be twice
that of the 100 ft run shown in the table, or 32.6% of 250W,
which is 81.5 watts lost as heat. Always be sure to use
adequate gauge speaker wire.
5. RACK-MOUNTING REQUIREMENTS
5.1 Mechanical
The 6125A and 4200A amplifiers are designed to
fit in standard 19-inch equipment racks. The front panel
rack-mount ears are sufficiently strong for most applica-
tions, however if you desire further integrity for mobile
racks, we recommend using the four additional holes in
the back of the chassis for supplemental rear-mounting (see
dimensional drawing for details).
5.2 Cooling
Be certain that both the front and back of the rack
have unhindered access to free air flow. Fan direction is
from front to back. It is not necessary to leave empty space
above or below.
5.3 Grounding
In some installations where the sound system is
sensitive to RF noise or system-induced oscillation, it may
be necessary to ground the amplifier’s chassis to the rack
enclosure. This is accomplished using star type
lockwashers on the four rack mounting screws. These star
washers will penetrate through the amplifier’s paint to ad-
equately ground the chassis to the rack.