Filter
Top Products
To connect the analyzer to an GPIB device
The analyzer is compatible with the General Purpose Interface Bus (GPIB).
Total allowable transmission path length is 2 meters times the number of
devices or 20 meters, whichever is less. Operating distances can be extended
using an GPIB Extender.
Analyzers with option UFG, 4 megabytes extended RAM and additional I/O, have
an additional GPIB connector. The additional GPIB connector, SYSTEM
INTERCONNECT, is only for connection to the spectrum analyzer used with the
Agilent 89411A 21.4 MHz Down Converter.
Connect the analyzer’s rear panel GPIB connector to an GPIB device using an
GPIB interface cable.
Caution The analyzer contains metric threaded GPIB cable mounting studs as opposed
to English threads. Use only metric threaded GPIB cable lockscrews to secure
the cable to the analyzer. Metric threaded fasteners are black, while English
threaded fasteners are silver.
For GPIB programming information, see the Agilent 89400 Series GPIB
Command Reference.
To connect the analyzer to an external monitor
The External Monitor connector is a 15-pin connector with standard VGA
pinout. The External Monitor connector can interface with an external,
multi-scanning monitor. The monitor must have a 25.5 kHz horizontal scan rate,
a 60 Hz vertical refresh rate, and must conform to EIA-343-A standards.
Connect the analyzer’s rear panel EXTERNAL MONITOR connector to an
external monitor using an appropriate cable.
For additional information, see ‘’EXTERNAL MONITOR connector’’ in the
analyzer’s online help.
Preparing the Analyzer for Use
7-16