Filter
Top Products
To connect the analyzer to a serial device
The IF section’s Serial 1 port is a 9-pin, EIA-574 port that can interface with a
printer or plotter. The total allowable transmission path length is 15 meters.
Connect the IF section’s SERIAL 1 port to a printer or plotter using a 9-pin
female to 25-pin RS-232-C cable.
Part Number Cable Description
Agilent 24542G 9-pin female EIA-574 to 25-pin male RS-232
HP 24542H 9-pin female EIA-574 to 25-pin female RS-232
To connect the analyzer to a parallel device
The IF section’s Parallel Port is a 25-pin, Centronics port. The Parallel Port can
interface with PCL printers or HP-GL plotters.
Connect the IF section’s rear panel PARALLEL PORT connector to a plotter or
printer using a Centronics interface cable.
Preparing the Analyzer for Use
7-15