Filter
Top Products
AVR200
13
English
TAPE MONITOR
The TAPE MONITOR button selects the audio output from a
cassette deck connected to the
TAPE IN phono sockets of the
AVR200. It also enables you to monitor a recording being made
on a 3-head cassette deck. Tape monitor status is shown in red
on the display.
When the tape monitor is selected, pressing other source
buttons changes the signal sent to the recorder.
CD
The CD button selects the source connected to the CD phono
sockets.
FM, AM
To select the integrated tuner function of the AVR200, press the
FM or AM button. See the section ‘Using the tuner’.
VOLUME control
To adjust the volume level of the loudspeakers, pre-amp outputs
and headphones use the VOLUME control. The volume level is
shown in the display while it is being adjusted. Three seconds
after the volume is adjusted, the display reverts to show the
selected input.
Note that different sources may require different settings of the
VOLUME control to achieve the same perceived volume level.
The volume can be controlled from 0dB over 80 steps.
BASS and TREBLE controls
Turn the bass and treble controls clockwise to boost response
or anticlockwise to cut response. For a fl at response leave the
controls in the 12 o’clock ‘notched’ position.
Pressing the
DIRECT button bypasses the bass and treble
controls and gives a small improvement to sound quality. If
you do not wish to alter the bass or treble controls, we
recommended that you select DIRECT.
after 3 seconds
DOLBY PL II SPEAKERS
VIDEO 1
dB
MUSIC
DOLBY PL II SPEAKERS
VIDEO 1
MUSIC
NOTE: TAPE MONITOR is a latching button: you will need to
press it again before selecting another source for listening.