Arcam AV888 Home Theater System User Manual


 
E-15
English
HDMI
AV SAT DVD VCR PVR OUT 2 OUT 1
HDMI connectors
AV, SAT, DVD, VCR, PVR
Connect the HDMI video outputs of your source equipment to these
corresponding HDMI inputs.
OUT 1
Connect this output to the HDMI video input of your main zone display
device.
OUT 2
Connect this output to the HDMI video input of your second display
device or to another HDMI display device in a second living space. As
the unit has only one processed video path, this signal will be a copy of
the signal on
OUT 1.
NOTE
All Zone 1 analogue video outputs will be disabled if
an HDMI digital video source is selected.
Component/RGB video
connectors
ese inputs are suitable for connection to source
devices which output Component (YUV or YPbPr) or
RGB high quality analogue video signals. ese signals
are usually available from DVD players, set-top boxes or
games consoles.
If you are connecting up to an RGB source you will
also need to connect the source’s Composite output to
the unit’s Composite input to act as a video sync. e
Composite signal should be on the same named input as
the RGB signals.
RGB video outputs on source equipment are oen on
SCART connectors. You will need to use a SCART to
‘RGB+Sync on phono’ breakout cable, available from
your Arcam dealer.
NOTE
When setting up the menus (later in this manual),
you will need to select whether the three-wire high
quality video input is Component or RGB for each
input. is is done on the ‘HQ Video In’ line in the
Input Cong menu. Failure to do this can result in a
green looking picture or a picture that is unstable.
Zone2 connectors
Z2 AUDIO OUT, Z2 VIDEO OUT
Connect these analogue audio
and video outputs to your
Zone2 equipment. See ‘Multi-
room Setup’ on page 50 for
information.
VCR
PVR
AV
SAT
DVD
S-Video and
Composite
connectors
VCR, PVR
Connect these inputs to the
S-Video and Composite
outputs of your available source
equipment.
AV, SAT, DVD
Connect the Component video outputs of your source
equipment to these inputs.
OUT
Connect this output to the Component video input of
your display device.
NOTE
Analogue RGB video output is not available from
the AVR500. e analogue three-wire high quality
video output is always congured as Component
video.