3M X55 Home Theater System User Manual


 
9
Setting up
Adjusting the projector's elevator
CAUTION ►Be careful not to pinch your finger on the occasion of the
handling of a base.
►Do not hold the base, lens or other project part to move the projector.
►Do not use the base to suspend the projector.
►Do not push or put anything on the both sides of the top of the projector.
1.
Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool
for at least 45minutes.
2.
After make sure that the projector has cooled adequately, slowly flip over the
projector, so that the bottom is facing up.
3.
Put the base on the bottom of the projector as shown in the figure. Then slide
it to the front of the projector until it locks into position. To remove it, slide the
base to the back of the projector pinching the lever of the base.
4.
Slowly turn the projector so that the top is facing up.
Base
Lever
Bottom of the
projector
Front