3M X45 Home Theater System User Manual


 
4
Part names
Part names
NOTE (*) About Restart switch: This Projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Y
video
audio in
1
rgb in1
contro
l
rgb in2 rgb out
audio in2
audio out
US
B
S-video
component video
CB/PB
CR/PR
Lens (
17)
Filter cover (
41)
(Air filter and intake vent
are inside.)
Elevator button (
8)
Elevator foot (
8)
Remote sensor (
16)
Zoom knob (
19)
Focus ring (
19)
Vent (
6)
AC inlet (
14)
Power switch (
17)
Elevator button (
8)
COMPONENT
VIDEO ports (
13)
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port (
13)
VIDEO port (
13)
CONTROL port
(
12)
Projector
Lamp door
(Lamp unit is inside.)
(
39)
Elevator foot (
8)
Bottom side
Speaker
Front-Right side
Rear-Left side
Control buttons
(See the following page.)
(
5)
Ports
(See below.)
Vent (
6)
AUDIO OUT port (
12)
Ports
AUDIO IN1 port (
12)
AUDIO IN2 port (
12)
USB port (
22)
Restart switch (*) (
47)
RGB IN1 port (
12)
RGB IN2 port (
12)
RGB OUT port (
12)
Kensington lock slot