3M X21i / X26i / X30n / X31/ X31i / X35n / X36 / X36i Home Theater System User Manual


 
16
[PICTURE-1] Tab
Function General Description
Gamma Switches the gamma mode.
Normal / Cinema / Dynamic / Custom
Custom Gamma Adjusts the gamma data.
[-]: Decrease the gamma value.
[+]: Increase the gamma value.
Color Temp Switches the color temperature mode.
Low / Middle / High / User
Custom User R Adjusts the red color level for the user mode of red color temperature.
100 / 90 / 80 / 70 / 60 / 50
Custom User G Adjusts the green color level for the user mode of green color temperature.
100 / 90 / 80 / 70 / 60 / 50
Custom User B Adjusts the blue color level for the user mode of blue color temperature.
100 / 90 / 80 / 70 / 60 / 50
Color Bal R Adjusts the red color balance.
[-]: Decrease the red color balance value.
[+]: Increase the red color balance value.
Color Bal G Adjusts the green color balance.
[-]: Decrease the green color balance value.
[+]: Increase the green color balance value.
Color Bal B Adjusts the blue color balance (blue).
[-]: Decrease the blue color balance value.
[+]: Increase the blue color balance value.
Sharpness Adjusts the sharpness.
[-]: Decrease the sharpness value.
[+]: Increase the sharpness value
Color Adjusts the strength of whole color.
[-]: Decrease the color value.
[+]: Increase the color value
Tint Adjusts the tint.
[-]: Decrease the tint value.
[+]: Increase the tint value.
My Memory Loads the data from the memory.
Load1 / Load2 / Load3 / Load4
Saves the current adjustment data into the memory.
Save1 / Save2 / Save3 / Save4
[Execute]: Performs each function.
Reset Initialize the selected function.
Color Bal R / Color Bal G / Color Bal B / Sharpness / Color / Tint
[Execute]: After the confirmation message, the selected function will be initialized.
[PICTURE-2] Tab
Function General Description
Position Adjust the display position.
[
]: Increase the vertical position value.
[
]: Decrease the vertical position value.
[
]: Increase the horizontal position value.
[
]: Decrease the horizontal position value.
H Phase Adjust the horizontal phase to eliminate flicker.
[-]: Decrease the horizontal phase value.
[+]: Increase the horizontal phase value.
H Size Adjust the horizontal size.
[-]: Decrease the horizontal size value.
[+]: Increase the horizontal size value.
Over Scan Adjust the over-scan ratio.
[-]: Decrease the over-scan value.
[+]: Increase the over-scan value.
Reset Initialize the selected function.
V Position / H Position / H Size / Over Scan
[Execute]: After the confirmation message, the selected function will be initialized.
© 3M 2012. All Rights Reserved.